Cambium 2.4 GHz PMP 120 Wireless Access Point, 2400AP

Cambium Networks
SKU:
2400AP
$1,095.00
Current Stock:

Out of stock, but we may be able to make magic happen!

Contact Us
The Motorola Canopy product line is the industry leader in point to multipoint and WISP deployments. Motorola Canopy access points provide the reliability, scalability, low latency and low subscriber cost to make allow any ISP to provide the highest SLAs in an extrrememly cost effective manner. Here are some things you should know about the Motorola Canopy before deployment.

Canopy Planning & Wireless Broadband Network Design Guide
Controlling Interference: The Motorola Canopy Approach
Canopy Performance in Broadband Wireless Access Systems
Wireless Bandwidth vs Throughput

Now a short system overview
The Canopy system operates in point-to-point and point-to-multipoint configurations at 2.4, 5.2 and 5.7 GHz. The 2.4 GHz Canopy modules support point-to-point links delivering 13 Mbps of effective throughput for distances up to 56 km (35 miles) as well as point-to-multipoint links delivering more than 6 Mbps of throughput for distances up to 24 km (15 miles). However where higher bandwidth backhauls are neccessary the Motorola Canopy PTP400 and PTP600 high speed wireless backhauls are perfect for the job.

Designed to deliver consistent and reliable wireless broadband service, the Canopy system gracefully scales to support large deployments. This is achieved through the systems unique synchronization capabilities using the Global Positioning System (GPS) as well as Canopys inherent interference techniques. The systems synchronization allows network operators to re-use frequencies and add capacity while consistently ensuring consistency in the quality of service to customers. As a result, subscribers can experience carrier grade service even those at the outer edge of the network. Synchronization also helps ensure the Canopy system modules transmissions do not interfere with each other. Canopy system modules are also extremely tolerant to interference from other sources. The Canopy systems industry-leading nominal Carrier to Interference (C/I) ratio of 3 dB ensures reliable communication when other transmitters are present.

The Canopy system hardware draws little power and its packaging is unobtrusive. Installation is easy, and the built-in audio and visual feedback indicators allow the unit to be installed with no special training. These characteristics facilitate initial deployment and network expansion as capacity needs increase.

NOTE: Each Motorola Canopy AP and SM REQUIRES 1 x ACPS110-03 to operate
WM #:
112509131
Antenna Type:
2.4 GHz 60 Degree Integrated Sector Antenna
Security:
DES, Proprietary scrambling mechanism; optional AES Encryption
Gain:
8
Series Tag:
PMP 120 Series
Item Type:
Access Point (AP)
Operating Tempature:
-40 to +60 degrees C
Mount Method:
Mast, Pole Mount
Outdoor Use:
Yes
Configuration:
HTTP, TELNET, FTP, SNMP Version 2C
Operating Modes:
Point to Multipoint, Point to Point
Network Connector:
1 x 10/100
POE Description:
Supported (802.3af)
Advertised Bridging Distance:
Up to 8 km (5 miles) with integrated antenna. Up to 24 km (15 miles) with passive reflector only on the Subscriber Module side.
Antenna Alignment:
Audible antenna alignment alarm
Data Rate:
10 Mbps Datarate, 6 Mbps Useful Throughput
Latency:
20ms
Modulation:
High Index 2-level Frequency Shift Keying (FSK) optimized for interference rejection
Radio Type:
Time Division Duplexing/Time Division Multiple Access (TDD/TDMA)
Receiver Sensitivity:
-86 dBm (typ)