Check items to add to the cart or select all
You're currently on:
Cambium / Motorola WB3860AA PTP 58600 Series Full, 5.8 GHz 300Mbps, Integrated Antenna, Full Hop, NLOS
Product Description
The Motorola 600 Series point-to-point 5.4 GHz and 5.8 GHz wireless Ethernet bridges provide more range and capacity in near- and non-line-of-sight (NLoS) environments, delivering carrier-grade service (99.999% availability).
Motorola combines Multiple-Input Multiple-Output (MIMO) and Intelligent Orthogonal Frequency Division Multiplexing with advanced signal-processing algorithms, allowing 600 Series solutions to create four simultaneous signals between pairs of transceivers at each end of the link without losing spectrum efficiency. This technique increases signal integrity by an unprecedented 300 times.
Incorporated in Motorolas MOTOwi4 portfolio, PTP 600 Series bridges are available in several models to meet your specific requirements:
Integrated Full: With up to 300 Mbps Ethernet data rate and a built-in antenna, the PTP 600 Integrated system is the perfect choice for any environment near- or non-line-of-sight, line-of-sight and high-interference environments where high throughput is a major requirement and/or dual E1/T1 capability is needed.
Integrated Lite: Operating in the 5.8 and 5.4 GHz frequencies, the Lite versions of the PTP 600 Series Integrated bridges include all the same robust technology of the full-speed versions, but at less cost. They are ideal solutions in any environment where you need more speed and bandwidth than the 43 Mbps provided by the Motorola PTP 400 Series bridges and/or single E1/T1 capability is required. With up to 150 Mbps Ethernet data rate, the Integrated Lite model is software upgradeable to 300 Mbps as throughput requirements increase.
In non-line-of-sight environments, both Connectorised systems can increase link availability up to 99.999%. Prior to purchase, you can use Motorolas PTP Link Estimator to predict link reliability and throughput for your specific wireless application.
Kit Includes:
- 2 x Outdoor Unit (ODU) - RF Unit
- 2 x Indoor Power Injector - PIDU PLUS
- 2 x Pole Mount Kit with Elevation/Azimuth Adjustment
*NOTE: 4 x ALPU-ORT Lightning Arrestors are required for every link.
WB3860AA Technical Specifications
| Original Sku | BP5830BH-2DD |
| WM Item # | 100700 |
| Manufacturer | Cambium / Motorola |
| Frequency | 5.8 GHz |
| Frequency | 5.8 GHz |
| Series | PTP 600 Series |
| Radio Power (max) | Varies with modulation mode and settings from 0 dBm to 25 dBm |
| Configuration | Web or SNMP using MIBII, WiMAX and private MIB |
| Radio Type | TDD (Time Division Duplex) |
| Data Rate | Dynamically variable up to 300 Mbps at the Ethernet (aggregate) |
| Receiver Sensitivity | Adaptive, varying between -91 dBm and -58 dBm |
| Modulation | Dynamic; adapting between BPSK single and 256 QAM dual |
| Security | Proprietary scrambling mechanism; optional AES 128 and 256 Bit Encryption |
| VPN | Supported |
| POE | Included |
| Distance | non-LoS Up to 6 Miles (10Km),near-LoS up to 25 Miles (40Km),LoS Up to 124 Miles (200Km) |
| Operating Modes | Point to Point Bridge |
| Antenna Alignment | Audible antenna alignment alarm |
| Channel Bandwidth | 30MHz |
| Frequency Range | 5725 MHz 5850 MHz |
| Operating Tempature | 40 to +60 degrees C |
| Mount Method | Mast, Pole Mount |
| Wind Load | 150 Mph |
| Weatherproof | Outdoor, Rugged, Weatherproof |
| Network Connector | 1 x 10/100/1000, 2 x T1/E1, 1 x 1000BaseSX (optional) |
| Polorization | Dual Polarized |
| Gain | 23 dbi |
| 3dB beamwidth, Azimuth | 7 degree |
| 3dB Beamwidth, Elevation | 7 degree |
| Antenna Type | 5GHz Dual Polarized Panel |
Write Your Own Review
You're reviewing: PTP 58600 Series Full, 5.8 GHz 300Mbps, Integrated Antenna, Full Hop, NLOS
You may also be interested in the following product(s)
|
Advanced Lightning Surge Suppressor Arrestor for Motorola Canopy and Orthagon
$195.00
|
BYO PTP Wireless Bridge Kit with Integrated AntennaFrom: $195.00 To: $16,190.00 |
Product Tags
Other people marked this product with these tags:
Add Your Tags:
Use spaces to separate tags. Use single quotes (') for phrases.
